Raspberry Pi Pico (Unsoldered Headers)

Raspberry Pi Pico (Unsoldered Headers)

The 1st MCU Board from Raspberry Pi – Pico

Raspberry Pi Pico is a tiny, fast, and versatile board built using RP2040, a brand new microcontroller chip designed by Raspberry Pi in the UK, now available in Singapore. Designed for physical computing projects that controls anything from small electronic components, LEDs, motors; reading information from sensors, or communicate with other microcontrollers.

• Compact and Easy-to-mount
• USB Micro for Power and Data
• Large RAM and Flash Size
• Programmable in MicroPython, C, and C++
• Flexible Power Input

Specification

• 21 mm × 51 mm form factor
• RP2040 microcontroller chip designed by Raspberry Pi in the UK
• Dual-core Arm Cortex-M0+ processor, flexible clock running up to 133 MHz
• 264KB on-chip SRAM
• 2MB on-board QSPI Flash
• 26 multifunction GPIO pins, including 3 analogue inputs
• 2 × UART, 2 × SPI controllers, 2 × I2C controllers, 16 × PWM channels
• 1 × USB 1.1 controller and PHY, with host and device support
• 8 × Programmable I/O (PIO) state machines for custom peripheral support
• Supported input power 1.8–5.5V DC
• Operating temperature -20°C to +85°C
• Castellated module allows soldering direct to carrier boards
• Drag-and-drop programming using mass storage over USB
• Low-power sleep and dormant modes
• Accurate on-chip clock
• Temperature sensor
• Accelerated integer and floating-point libraries on-chip

What’s Included

• 1 x Raspberry Pi Pico – without pre-solder header
• 2 x 20-pin Straight Header Male Pin*

*A pair of 20-way male headers are included. BUT, you will need to solder it on your own.